Used variable speed in Oregon, USA

McDonough Rollfeed Resaw, 54" Tilting Rollfeed Resaw

Used McDonough 54" Tilting Rollfeed Resaw. Resaw has been reconditioned. Mechanical strain. Non-rotating upper wheel shaft with bearings mounted in wheel. Top wheel is 7/8"-thick at edge of rim and has 7-1/4"...

TYM 4820H Tractor/Loader

• Manufacturer: TYM

TYM 4820H Tractor/Loader Information provided by TYM Boasting a 4 speed transfer case! “more variable speeds for you!” 48 hp Diesel Engine 4×4 Hydrostat Transmission 4 F x 4 R (4-Range) Need Financing? Get Pre-Ap...

Timesavers Belt Sander 30" Wide Single Head Top Wide

• Manufacturer: Timesavers

Used Timesavers 30" Top Wide Belt Sander. 30 HP, 220/440V motor. Variable speed drive for 30"-wide feed belt. Dedusting brush on outfeed end. Air belt tracking. Amp meter for monitoring belt condition or st...

TYM 4820CH Tractor/Loader

• Manufacturer: TYM
• HP: 48 horsepower
• Cylinders: 4 cyl.

TYM 4820CH Tractor/Loader 4WD 48 HP – Diesel, EPA TIER CERTIFIED, Vertical, 4 Cycle, Water Cooled, 4 Cylinder 4 RANGE HST TRANSMISSION 38.4 HP Independent PTO Category 1 3-Point Hitch with telescopic lower link a...

Weinig Moulder Through-Feed Model U14N 7-Head

• Manufacturer: Weinig

Used Weinig Model U14N 4-3/4" X 5-1/2" (120 X 140 mm) 7-Head Through-Feed Moulder, S/N 854-5645. Head configuration is bottom, right, left, right, top, bottom, universal. Variable speed from 20 to 118 feet per ...

urner 42” Twin Band Tilting Feedroll Resaw

One (1) Used Turner 42” Twin Band Tilting Feedroll Resaw. Two (2) 25HP, 220-440-volt motors. Variable-speed hydraulic feedroll drive. Feedrolls open 8”-wide and will handle 12” stock under saw guides. Feedrol...

Turner Rollfeed Resaw, 52" Rollfeed Resaw E-52

Used Reconditioned Turner Model E-52, 52" Rollfeed Resaw with D.C. variable-speed feedroll drive. All ball and roller bearings throughout. Mechanical weight strain. Wheels are 6-3/8"-wide solid disc-type. Roll...

Iida Moulder, Woodsman MX-181 5-Head Through Feed Moulder

• Manufacturer: Woodsman

Used Iida Woodsman MX-181 5-Head Through Feed Moulder, S/N MX-181 0051987, built 1987. 180mm X 125mm (7” X 5”) capacity. 6,000 RPM spindles. 20-100 FPM variable feed speeds. Pneumatic tensioned powered feed r...

PM 1200 Vertical Bale Shaver

PM 1200 Vertical Bale Shaver If you are using peat moss or pre-mix substrate, the PM1200 Bale Shaver will produce a consistent texture and flow throughout the entire bale. Just place the palletized bale inside th...