Used Shell And Tube Heat Exchangers in Utrecht, Netherlands

1995 Tetra Pak Spiraflow TTF-38s/16c-3-1

• Manufacturer: Tetra Pak
• Model: TTF38

Monotube, outer diameter 38 mm (smouth) and inner diameter 16 mm (coagurated). 6 Tubes of 3 meter. Product side: pressure up to 60 bar - temperature up to 160 °C - volume: 1 liter per tube, total volume 6x 1 = 6 ...

1959 Stork DS

• Manufacturer: Stork

Stork DS Pre-sterilizer no: 13384 Capacity: 2000 liters per hour

2005 APV Crepaco SSHE

• Manufacturer: Crepaco

Scraped heater - cooler set, used as sterilizer, including 3 holding tubes 30 - 30 - 210 seconds (various options possible on swingbend panel). Each scraped heaterexchanger has a temperature indicator on water an...

Tetra Pak Multitube

• Manufacturer: Tetra Pak

Tube heat exchanger, straight design multitube, length: 6mtr, 7 inner tubes with diameter 22 mm, outer tube coagurated. Outer tube diameter 113 mm. Capacity: 0,41 m2x7=2,9m2. With connections product in/out DN 80...

Crepaco 1VT422

• Manufacturer: Crepaco

Scraped surface heat exchanger (SSHE). 1 Vertical Product cylinder, tube: Ø 96 mm, length 1,500 mm, rotor Ø 38 mm with 2 scrapers. Cylinder material: stainless steel. Surface per tube 0,19 m² and volume per tube ...

Het Stempel BV N.N.

• Manufacturer: Het Stempel BV

Tubular heat exchanger, sanitary (THE). Monotube, 1 compartments, Straight design, 3 tubes, 1 section. Length inner tube: 200 cm, length outer tube 180 cm. Outer diameter 38 mm, inner diameter: 22,5 mm. Connecti...

Het Stempel BV N.N.

• Manufacturer: Het Stempel BV

Tubular heat exchanger, sanitary (THE). Monotube, 1 compartment, Straight design, 8 tubes, 1 section. Length inner tube: 302 cm, length outer tube: 288 cm. Outer diameter 76 mm, inner diameter: 48 mm. Connection:...

1996 Tetra Pak TTF-2 84c / 38c-6-1 & BSTF-2 54c / 4x16S-6-1

• Manufacturer: Tetra Pak
• Model: TTF2

Tubular heat exchanging unit. Existing out of: 14 tubes (7 sets of 2), multitube, straight design, 1 section, length: 6 mtr, outer diameter 54 mm coagurated (spiral wound), 4 inner tubes of diameter 16 mm, smooth...

1988 Stork Sterideal

• Manufacturer: Stork
• Model: STERIDEAL

Stork Sterideal. UHT line, consists of Stork UHT, Tubular indirect heating, 4 sections of triple tube (tube in tube in tube), Stork holding tube and Skid with infeed tank. new Tubular heatexchanger in 2012 only u...

N.N. SS insulated lab holding

• Manufacturer: N.N..

Laboratory insulated mobile holding with 3 loops. A.) 1.66 l - 1 min. 100 l/h. B.) 3.32 ltr - 2 min - 100 l/h. C.) 3.23 ltr - 2 min - 100 l/h. Connections: 2 x 1" Din - 2 x 15 mm Din. Total dimensions: 80x43x105 ...

N.N.. SS

• Manufacturer: N.N..

Double jacketed pin mixer. Shaft diameter 85 mm, 3 rows with 14 pins (42 pieces total) - cylinder diameter 250 mm with 2 rows with 19 and 20 (total 39) pieces. Cylinder length 195 cm. Connections: 2 x 2" Din and ...

Tubular Heatexchanger

Monotube, inner diameter (product) 23mm outer diameter (water) 40mm, 42 tubes x 3 mtr each. total dimensions: Length 3.00 mtr x Width 1.30 m, Height 1.50 mtr. On a stainless steel frame. Flexible in using, many l...

1972 Paasch & Silkeborg H-3575

• Manufacturer: Paasch & Silkeborg

Tubular Heatexchanger 36 tubes, total dimensions: L 320cm X W 80cm X H 140cm

2009 Tetra Pak Hot water set / MT-108

• Manufacturer: Tetra Pak

Hotwater set with tubular heat exchanger, steam valve (Samson) and piping. Pressure: shell 0-15 bar, tubes 0-40 bar. Temperature: shell 0-180 °C, tubes 0-180 °C. Volume: shell 9,3 liter, tubes 6,1 liter.

N.N. Monotube

• Manufacturer: N.N.

Monotube. 1 Tube with internal spiral. Length: 150 cm, outside diameter 70 mm, inside diameter 50 mm. Connections, product: DN50 Clamp and service: DN16, DIN.