Nardini CNC lathe, Logic 250, 10″ plate
- Manufacturer: Nardini
Used CNC lathe for sale, Nardini, Logic 250. It is located in the factory and is operating normally. Dear customer, this is a used machine and will be sold as is. Therefore, if you have any questions about its op...
Nardini CNC lathe, model Logic 195, 1,000 mm
- Manufacturer: Nardini
Nardini CNC lathe, Logic 195 model. It is located in the factory, plugged in, and operating normally. We have five machines similar to this one, all Logic 195 models and approximately the same model year. They ar...
2005 CNC lathe brand Nardini Logic 195 II (Ø x Comp) 440 x 1000 mm
- Manufacturer: Nardini
Nardini CNC Lathe Model Logic 195 III Year 2005 MCS SX Control Pneumatic Plate Pneumatic Tailstock Tool Turret Maximum Diameter over the Rail 440 mm Maximum Diameter over the Carriage 250 mm Spindle Bore Diameter...
2024 NARDINI LOGIC 350 CNC LATHE
- Manufacturer: Nardini
Nardini Logic 350 CNC Lathe Fagor Control 3050 Point-to-Point 8-Position Hydraulic Turret Hydraulic Platen and Tailstock
Joinville - State of Santa Catarina, Brazil2009 NARDINI LOGIC 195 II CNC LATHE
- Manufacturer: Nardini
Nardini Logic 195 II CNC Lathe Year 2009 8-position BPT63 Turret Onça PP160 Pneumatic Plate Pneumatic Tailstock Electronic Crank Busbar grinding completed General overhaul of spindles and bearings General overhau...
2008 NARDINI LOGIC 195 II CNC LATHE
- Manufacturer: Nardini
Nardini Logic 195 II CNC Lathe Maximum diameter above the bed: 440 mm Maximum diameter above the carriage: 250 mm Spindle bore diameter: 52 mm 6" pneumatic platen Pneumatic tailstock 8-tool turret 3500 RPM 220V T...
Joinville - State of Santa Catarina, Brazil
CNC lathe brand Nardini model ECO-14 500 mm between ends
- Manufacturer: Nardini
Nardini CNC Lathe ECO-14 CNC VS Model MCS RX505 Control 500 mm nose spacing 7.5 HP Motor A braking resistor was installed A CFW-11 frequency inverter was installed Working in industry
2012 CNC Lathe brand Nardini Logic 350 (Diam x Comp) 700 x 1900 mm
- Manufacturer: Nardini
Nardini CNC Lathe Model Logic 350 Year 2012 Fanuc-0i Control 315 mm 3-jaw chuck, mechanical, manual Diameter over the bar 700 mm Diameter over the carriage 400 mm Spindle hole diameter 100 mm Distance between the...
2008 NARDINI LOGIC 350 CNC LATHE
- Manufacturer: Nardini
Nardini Logic 350 CNC Lathe Year 2008 Diameter 700mm Between ends 2000mm New Rohm hydraulic plate
Tip: Enter manufacturer, model or keyword
