TCC-45 SVO Cutting Machine in Laihia, Ostrobothnia, Finland
New
Doubleclick to zoom in
Contact the seller for
additional photos and information.
Specifications
- Condition
- new
- Wall thickness
- Copper, Aluminum: 0,4–1,5 mm | 0.02" - 0.06" Steel: 0,4–1 mm | 0.02" - 0.04"
- Repeatibility accuracy (cutting feed)
- ±0.2 mm/1 m
- Tube materials
- Aluminium, Copper, Steel
- Compressed air supply
- 6 bar = 600 kPa
- Connected power
- 6,3 kW
- Fuses
- Max. 3 x 63 A (380–480 V)
- Pipe diameters
- 1,5–22 mm | .060” – 0.866”
- Pipe material
- Copper, Aluminium, Steel, Stainless Steel, CuNi, Brass
- Machine type
- Industrial machines
- Process
- Cutting
- Max. wall thickness
- Cu & Al 1,5 mm | 0.06”, Steel 1 mm | 0.04”
- Maximum tube diameter
- Copper, Aluminum: Ø22 mm | 0.866’’ Steel: Ø12,5 mm | 0.5’’
- Subcategory
- Tube fabrication machinery
- Subcategory 2
- Tube straightening/cutting
- Listing ID
- 98376549
Description
TCC-45 SVO Automatic Rotary Cut-off machine with Servo Motor based feeding
The TCC-45 SVO is an Automatic Rotary Tube Cut-off Machine for cutting of all malleable materials such as aluminum, copper, steel and stainless steel. The tube diameters are Ø1,5–Ø22 mm | Ø0.06” – 0.866’’.
The servo-controlled roll feed system enables quick and easy cutting length changes using the touch screen. TCC-45 SVO was designed for applications with cut lengths exceeding 2 m (79’’). It provides a smoother and faster method of feeding longer tube, especially when compared with the standard hitch-feed method. The TCC-45 SVO is typically used for cutting tubes from coil.
The TCC-45 SVO is an energy saving solution and thus an ecological alternative to machines in which tube feeding is powered using compressed air. After cutting, the cut tubes are transferred to a tube collection table that ensures straight run of tubing and allows even roll down to the collection point.
ADVANTAGES OF T-DRILL CHIPLESS CUTTING
No expensive saw blades needed
Longer blade life
No material loss between cuts
No chips – no need for deburring system
No investment in chip handling system
Biological lubrication – no need to wash before brazing
Fast cycle time – maximum ~ 3,000 pieces / hour
Cuts always exactly 90° to the tube run
Inline endforming available after cutting (1-8 hits)
– replaces the investment in one additional production step
Low operating noise level
Waste minimizing and cut piece optimization systems
Trusted: more than 500 TCC machine references globally