Tektronix PG3L-P3L300-B^ in Farmingdale, NJ, USA
New
Doubleclick to zoom in
Contact the seller for
additional photos and information.
Specifications
- Condition
- new
- Cal
- Calibration Available
- As-is
- Unit Sold AS-IS
- Category
- Test Generators in USA
- Subcategory
- Accessories
- Subcategory 2
- Test & measurement equipment
- Subcategory 3
- Calibration, service, upgrade options
- Listing ID
- 94660815
Description
The P300 Inputs probe provides a method for communicating user clock and user event information to the PG module. The P300 is not necessary for operation of the unit. Further, a user need not even connect the P300 to the PG module. Note that in the Quick Start (4.3 above), there is no mention of the P300.
The Inputs probe supports both a differential clock input and a single-ended clock input. The selection of the clock source is via a jumper accessible from the bottom of the probe.
Each clock also has a selection of terminated or unterminated, again jumper-selectable from the bottom of the probe. The termination value for the differential probe is 100 ohms and the single-ended one is 50 ohms. However, these termination resistors are also accessible to the user from the bottom of the probe. They are in standard 0603 packages. The user can desolder the one present and replace the termination resistor with the desired value.
J1 1-2 disconnects the differential termination.
$1,145 USD