Vertical cnc milling machine 50C VMC cnc vertical machining center machine in Nanjing, Jiangsu, China
New
Doubleclick to zoom in
Contact the seller for
additional photos and information.
Specifications
- Condition
- new
- Serial number
- name
- Project
- Specifications
- Trip
- X/Y/Z axis
- Distance from spindle nose to workbench
- mm
- Distance from spindle center to column guide rail surface
- mm
- Worktable
- Table size
- Maximum load of workbench
- kg
- T-groove
- No/mm
- Principal axis
- Spindle specifications
- Spindle speed
- rpm
- Tool magazine device
- Tool magazine form/tool change time (tool setting)
- Magazine capacit
- tools
- Maximum tool diameter (temporary tool)
- mm
- Maximum tool diameter (no temporary tool)
- mm
- Maximum tool length
- mm
- Maximum tool weight
- kg
- Movement rate
- X、Y、Z axis Rapid feed
- Cutting feed rate
- m/min
- Electric motor
- Spindle power/torque
- X-axis servo motor
- kW，Nm
- Y-axis servo motor
- kW，Nm
- Z-axis servo motor
- kW，Nm
- Precision (vdi german standard)
- Positioning accuracy (VDI full stroke)
- Repeated positioning accuracy (vdi full stroke)
- mm
- Power demand
- Power requirements
- Air source requirements
- kg/cm
- Machine tool dimensions
- L * W * H
- Weight
- t
- 1
- system
- 2
- Spindle servo motor
- 3
- X、Y、Z servo motor
- 4
- X、Y、Z Shaft lead screw bearing
- 5
- X-axis ball screw
- 6
- Y-axis ball screw
- 7
- Z-axis ball screw
- 8
- X-axis linear guide rail
- 9
- Y-axis linear guide rail
- 10
- Z-axis linear guide rail
- 11
- Tool magazine
- 12
- Automatic lubrication system
- 13
- Main pneumatic components
- 14
- Main electric components
- 15
- Main drive toothed belt
- 16
- air conditioner
- Category
- Machining Centers in China
- Subcategory
- Cnc machining center
- Listing ID
- 92489392
Description
Description
Vertical cnc milling machine 50C VMC cnc vertical machining center machine
VMC-60S Optical and mechanical characteristics：
The machine bed is made of HT300 high-grade cast iron; Germany INA line rail is adopted, and the width of X/Y/Z three-axis rail is 45/45/45mm; The X/Y/Z three-axis guide rail spans are 340/745/440mm respectively; The three shafts all use C3 high precision lead screws with a diameter of 40 and a pitch of 12. The three shafts use five FAG original bearings (3062), three at the motor end and two at the tail end, and are pre tensioned; X-axis and Z-axis adopt 6-slider mode to ensure cutting rigidity; BT40-150 high rigid main shaft is used for circular spraying;
7.The lead screw guide rail lubrication system adopts fully automatic intermittent thin oil lubrication; All oil pipes are made of pure copper;
3、 Main technical parameters
3、 Main technical parameters
If any supplier fails to supply, it will be replaced by a brand of no less than the same quality.