Cat C32 ACERT Generator Set (IMO II) in Mesa, AZ, USA
Used
Doubleclick to zoom in
Contact the seller for
additional photos and information.
Specifications
- Condition
- used
- Minimum rating
- 550 eKW (688 kVA)
- Maximum rating
- 940 ekW (1175 kVA)
- Frequency
- 50 Hz or 60 Hz
- Aspiration
- Twin Turbocharged-Aftercooled
- Bore
- 5.7 in
- Stroke
- 6.4 in
- Displacement
- 1,959 in³
- Governor type
- Electronic
- Fuel system
- Diesel
- Engine model
- Vee 12, 4-Stroke-Cycle Diesel
- Length
- 168.34 in
- Width
- 65.79 in
- Height
- 70.86 in
- Weight - estimated
- 15,721 lb
- Speed
- 1500 rpm (50 hz) or 1800 rpm (60 hz)
- Emissions/fuel strategy
- IMO II
- Excitation
- permanent magnet (PMG)
- Pitch
- 2/3
- Number of poles
- 4
- Number of bearings
- 2 roller bearings
- Number of leads
- 6
- Insulation
- Class H
- Voltage regulation
- ± 0.5% (steady state)
- Frame size
- 1423, 1467
- Ip rating
- Drip Proof IP 23*
- Alignment
- Closed-coupled adapter
- Wave form deviation - line to line
- 3.0%
- Voltage regulator
- Cat® Digital Voltage Regulator (CDVR)
- Telephone influence factor (tif)
- 50
- Category
- Generator Sets in Arizona
- Subcategory
- Marine generator sets
- Listing ID
- 82813477
Description
Separate circuit after-cooled (SCAC)
Turbocharger, jacket water cooled
Turbocharger inlet, 152 mm (6 in) OD straight connection
If an EMCP panel or MGCP option is not chosen as optional equipment, then start/stop controls must be provided by the customer
Electronic diagnostics and fault logging
Engine Protection Mode for extended ambient conditions
Electronic fuel/air ratio control
Separate Circuit After-Cooling (SCAC) for Heat Exchanged (HEX) & Keel cooled engines
Jacket Water (JW) and SCAC Heat Exchangers Shell & Tube for HEX cooled engines
SCAC pump, gear driven
Jacket water pump, gear driven
Sea water pump, bronze impeller, gear driven, for HEX cooled engines only
Jacket water HEX with Sea water pump Connections: 76.2 mm (3in) ID Standard
4 Bolt ANSI Flange Connection
Jacket water HEX without Sea water pump Connection: 2.5" hose barb connection (inlet), 76.2 mm (3in) ID Standard 4 Bolt ANSI Flange (outlet)
Keel Connections: 76.2 mm (3in) ID Standard 4 Bolt ANSI Flange Connection