Computer Numerical Control Envelope Die-Cutting Machine (CPC-NA25) in Camarillo, CA, USA
New
Doubleclick to zoom in
Contact the seller for
additional photos and information.
Specifications
- Condition
- new
- Cutting force
- 28 tons (25 Metric Tons)
- Cutting stroke
- 5.9” (150 mm)
- Maximum daylight
- 10.4"-5.2" (263-133 mm)(Head to machine bed)
- Head size
- 19.7"D x 19.7"W (500 x 500 mm)
- Main motor
- 3 HP
- Series
- CPC-NA25
- Category
- Presses in USA
- Subcategory
- Metalworking equipment
- Listing ID
- 73171513
Description
This 3 axis computer controlled hydraulic travelling head machine features 25 tons of available tonnage and a 19.7”D x 19.7”W head size.
Features
3 AXIS COMPUTER CONTROLLED HYDRAULIC TRAVELING HEAD DIE CUTTING MACHINE – The CPC-NA25 is a hydraulic computerized traveling head press producing 25 metric (28 U.S.) tons of cutting force. With two axis control (or three axis head rotation), this machine saves material, reduces labor, increases productivity, extends die life, and assures cutting quality.
Feed System Features
Spring Loaded Material Side Guide – For material alignment. The spring device helps push material into the correct position where a hard stop would force the material to curl up.
Y Axis Rear Guide and Clamping Unit – Clamping from the top and bottom results in a tighter grip than just clamping from one direction. The clamps include an air blower for accurate lift alignment and are able to retract when there is a cut at the clamp’s position.