RKC VGR-B Paperless Recorder with digital input/output, 9 channels in Wilmington, NC, USA
New
Doubleclick to zoom in
Contact the seller for
additional photos and information.
Specifications
- Condition
- new
- Number
- 9 points
- Measurement interval
- 100 m second
- Signal
- DC voltage, DC current (using external shunt resistor), thermocouple, RTD
- Influence
- External resistance (thermocouple): Approximately 0.18 μV/Ω Input lead resistance (RTD): Maximum 5 Ω per wire
- Pv digital filter
- 0 to 99 seconds (OFF when 0 is set)
- Scaling range
- -32,000 to 32,000 (DC voltage, DC current input) Decimal point is programmable
- Unit sign
- Preset units or 20 units (each unit eight characters or less) that can be made
- Square root extraction
- PV ratio + PV bias
- Math function
- Number of math channel: 36 channels Arithmetic, general, multiplication and F-value calculation can be computed with each math channel The content of the math can be set and be confirmed only with the Parameter Loader Software (standard supplied)
- F-value computation function
- F-value of each channel (fatal value of the bacterium by the heating sterilization) is computed from the measurement temperature The content of the computation can be set and be confirmed only with the Parameter Loader Software (standard supplied)
- Memory
- External: SD memory card (SD/SDHC) Internal: Approximately 100 MB Capacity: SD: Maximum 2 GB; SDHC: Maximum 32 GB
- Record data
- Main: Trend graph, event data, message data Sub: Trend graph (The record condition can be selected from "sync.", "Alarm", "DI")
- Cycle
- Recording: 1 second to 60 minutes (SUB record is possible 100 m second) Data saving: 1 hour to 1 year Data is first saved to the internal memory and then copied to the SD card at the specified cycle. When the internal memory is full or when recording is stopped, data is saved to the SD card.
- Data
- Trend: Minimum/maximum/current/average (selectable) value Format: Binary or binary + CSV format (selectable) Other record: Alarm status, message
- Memory remaining capacity display
- When the SD card is full, recording is stopped or data can overwrite oldest data (whichever is selected)
- Digital input/output
- Number of digital inputs: 9 points, Mon-voltage input (same common) Digital input function: Recording RUN/STOP, message setting, multiplication value RESET LCD backlight ON/OFF Number of digital outputs: 12 points, open collector output (same common) 30 V DC, 20 mA/point Digital output function: Alarm output
- Category
- Test Generators in USA
- Subcategory
- Temperature
- Subcategory 2
- Temperature recorders
- Listing ID
- 105919656
Description
Capable of measuring data in real-time on the liquid crystal display, this recorder is a paperless type that can save the measured data to an SD memory card. In addition, it can operate easily with the liquid crystal with the touch panel.
Features
Touch screen operation
Maximum 12 points (in the recorder) and additional 36 points of inputs (external devices connected via Modbus Master), total 48 inputs
Ethernet is supplied as standard
Touch screen operation
User friendly interface through a 5.7" (14.48 cm) LCD touch screen. Most of daily operations are achieved on the touch screen.
Basic display screens
Real-time trend
Bar graph
Digital
Historical trend
Event history/communication history
Recording starts immediately after pressing the REC button
Pressing the REC button starts recording. Data is stored into the SD card. With the supplied software, the recorded data can be easily viewed and managed.
$4,400 USD