TB-2715 | NI TERMINAL BLOCK in Fujian, China

NI TB-2715 TERMINAL BLOCK
NI TB-2715 TERMINAL BLOCK Use wire cutters and wire insulation strippers to strip no more than
1. Remove the terminal block cover by unscrewing the two cover screws using the 0.10 in. slotted screwdriver. 2. Apply the appropriate quick reference label to the inside of the top cover as shown in Figure 2. This label provides the corresponding signal names on the PXI module for each pin numbe 3. Loosen or remove the strain-relief bar by loosening the two strain-relief screws with a Number 1 Phillips screwdriver. 4. Use wire cutters and wire insulation strippers to strip no more than 7 mm of insulation from the wire ends. 5. Use Figures 3 and 4 to find the 653X and 660X signals that correspond to the screw terminals on the TB-2715. Please note that lines 19, 35, 43, and 56 are not connected.