74" x .375" x 55,000 Lbs. Hydrochloric Push Pull Pickle Line () in United States

- Thick Material: 90,000 PSI

- Thick Material: 35,000 PSI

Maximum Shear Strength: 90,000 PSI

Maximum Coil Weight at Uncoiler: 55,000 Lbs.

Maximum Coil Weight at Recoiler: 55,000 Lbs.

Maximum Coil Width: 74"

Maximum Strip Thickness: .375"

Minimum Strip Thickness: .045"

Coil OD (Entry): 80"

Coil O.D. (Exit): 74"

Coil ID (Entry): 20" to 33"

Coil ID (Exit): 24"

Maximum Line Speed/Strip Speed: 300 FPM

Tonnage Chart per Various Thickness Ranges: Average 300-500 tons per 12 hour shift. Average Thickness 0.120". Additional Pickle Tank Could Add 20% or More Capacity.

Maximum Output (Nominal Thickness): 25,000 Tons/Month

Electrical Supply (Input): 380V/3Ph/50Hz or 460V/3Ph/60Hz

Air Supply Required (Input): 500 Cubic Feet/Minute @ 100 PSI

Air Supply Required for Blower for Drying Strip: 50,000 Cubic Feet/Minute

Line Direction (Standing at Control Console): Left to Right

Complete Line With the Following Components:

1. 3-Coil Pusher Type Ramp or Rack

2. Coil Loader

3. 30 MT Capacity Double-End Cone Uncoiler with Large Wichita Heavy-Duty Air Cooled Brakes

4. Peeler and Hold Down Roll

5. Leveler/Processor/Flattener

6. Hydraulic Cropping Shear and Conveyor Rollers

7. Pre-Clean and Pre-Heat Section with Heavy-Duty Squeegee Rolls

8. Two (2)-60' Long Acid Tanks with Piping and Heavy-Duty Rubber Covered Squeegee Rolls for Minimum HCL Requirement

9. Exit Inside and Outside Squeegee System

10. Heat Exchangers and Hot Storage Tanks and Pumps with Automatic and Manual Controls

11. Multiple Stage Scrubber for Clean Atmosphere

12. Multiple Stage Hot Water Rinse Section with Heavy-Duty Squeegee Rolls for Minimum Water Use

13. Chevron Air Blow-Off System (After Rinse Section)

14. Oiling Rolls and Tension Bridle Roll Combination with Primary Oiling System for Oil or Dry Pickling

15. Mechanically/Hydraulically Actuated Edge Guides and Starting Guides on Carry-Over Conveyors

16. Squaring/Cropping Shear

17. New 5-High Corrective Cassette Type Leveler (Quick Change and Roll Cleaning) (Optional)

Max Leveler Speed: 400FPM

Thickness Range: .400" at 40"

.250" at 60"

Number of Work Rolls: 15

Work Roll Diametere: 3"

Roll Face: 84"

7 Flights of Back Ups

Motor: 200HP

18. Oil Tank, Pump, and Recovery System

19. Threading Table with Bridle Rolls

20. Recoiler with Automatic Edge Control and Hold Down Roll

21. Footage Counter

22. Steering

23. Exit Floor Type Coil Car

24. Digital Scale to Interface with Computer System

25. Boiler with Water Softener

26. Rinse Water pH Control

27. Storage and Holding Tank with Pumps and Piping

28. Testing Laboratory

29. Lubrication System and Wear Components

30. Electrical

31. Hydraulics and Pneumatics

Installed and Running