- Trusted Seller
RAS 69.20
- Manufacturer: RAS
- Power requirement: 3 kW
Type of control: conventional | Freight basis: EXW, free on truck unpacked | Storage location: Leipzig 5 | Sheet width: 2004 mm | Plate thickness: 2,5 mm | Distance between columns: 2040 mm | Total power require...
Leipzig, Germany - Trusted Seller
1988 Strojaren XONM 2000/2A-5
- Manufacturer: Strojaren
- Power requirement: 1.76 kW
HYDRAULIC FOLDING MACHINE operation via control panel with boom as well as via foot switch bending angle: sharp bending = up to 135° with 2mm sheet metal stroke of the upper beam = 250mm stroke of the lower beam ...
Leipzig, Germany - Trusted Seller
1992 Stückmann&Hillen 241 05
- Manufacturer: Stückmann&Hillen
- Power requirement: 4.5 kW
This is a hydraulic swing bending machine bending capacity 2,5mm with approx. 400N/mm² strength Hydraulic OILTECH with approx. 200 liters
Leipzig, Germany - Trusted Seller
1982 FASTI 2045 - 15/1,5
- Manufacturer: Fasti
- Model: 2045 - 1515
- Power requirement: 1.3 kW
- adjustment of the upper cheek 350mm - adjustment of the bending cheek / lower cheek 60/60 motoric - bending edge up to max. 10mm radius - without back gauge - upgrade possible -manual counter - foot pedal (peda...
Leipzig, Germany - Trusted Seller
WMW SBM 1000-1
- Manufacturer: WMW
- This swivel bending machine is equipped with two rear supports. Size of the round steel support = Ø 25 x 750mm, with linear scale. - Left side with counterweight.
Leipzig, Germany - Trusted Seller
Folding Machine Hesse+Co GmbH
- Manufacturer: Hesse
- Power requirement: 2.25 kW
Machine without foot switch but this is pre-equipped the upper beam was converted to 60 mm adjustment by the previous owner higher is only possible when dismantling for automatic operation the foot control is mis...
Leipzig, Germany
Tip: Enter manufacturer, model or keyword