Used Presses in Saitama, Japan

2016 Micromachining Laboratory LLC MCP-DT-J1035 (Precision Tabletop Press)

• Manufacturer: Limited Liability Company Micro Fabrication Laboratory

Product name: Other Presses | Main specifications: Precision Benchtop Press Stroke length: 40mm | Slide adjustment: Electric | Open height: 185

2008 Amada TPWL200

• Manufacturer: Amada
• Model: TPWL-200

Product name: Transfer press | Main specifications: Pressure capacity: 200t, Strokes per minute: 25-45spm, Stroke length: 250mm, Die height: 500mm, Slide adjustment: 110mm, Rapid stop time: 18ms, Slide lower dim...

1992 Asai Industry DSP1600A 【150t Die-presser】

• Manufacturer: Acai Industry

Product name: Hydraulic press (100T～) | Main specifications: Rigid single-acting straight-side hydraulic type, V-block 1600×1200 mm, Pressing capacity 150t, Hooking/holding capacity 40t, Reversing capacity 3...

2011 SANKI SEIKO SDP-1612-200

• Manufacturer: Tres fertilizante

Product name: Hydraulic press (100T～) | Main specifications: Processing capacity 400-2000 kN, pulling capacity 570 kN, table area 1600 x 1200 mm, stroke 1170 mm, maximum die weight 8 TON, maximum upper die weigh...

1995 Negami Double acting hydraulic press (100t press)

• Manufacturer: parte superior de la raíz

B:1800x1150mm ST:600mm cusion tempture controller Product name: Hydraulic press (0T to 100T) | Main specifications: Capacity: 100t Pull capacity: 12t Stroke length: 600mm Adjustment amount (from lower limit): 350...

2005 Yamamoto Tekko TC-600-1W

• Manufacturer: Yamamoto Ironworks

Hot Molding Press Top Ram Type Equiped with an electric oil heater for heating platens Platen:1250x1250mm Stroke:400mm approximately 120 degrees

2014 Mikado MKP-100S

• Manufacturer: Mikado (lake)

Product name: Hydraulic press (0T to 100T) | Main specifications: Under maintenance now... Please wait a moment.

Dainichi Seiko DGM-250 T type

• Manufacturer: Dainichi

By using urethane made for the front and rear rolls it surely feeds even very thin materials! Since the platen has no roll Feed smoothly without collapsing even thin material! Even though Veneer is extremely thin...

Dainichi Seiko DGM-250 THD type

• Manufacturer: Dainichi

By using urethane made for the front and rear rolls it surely feeds even very thin materials! Since the platen has no roll Feed smoothly without collapsing even thin material! Even though Veneer is extremely thin...

Otsuka Engineering Elite-500

• Manufacturer: Otsuka Engineering

A presser device with excellent design It produces a beautiful cutting surface. Prevent rebounding of material with repulsion prevention device.

PLS-2400TW

This machine is an Ito Sangyo flash press. With drawer Startup Operation verified. Condition: Used Operation: Verified Model: PL-2100TW Bed area: 1100mm×2150mm Upper-lower gap: 750mm Total pressure: 7000kg Moto...