New Machine Tools in Tuscany, Italy

C.L.O.M.E.A. PVC filling strips

• Manufacturer: C.L.O.M.E.A.

PVC filling strips

C.L.O.M.E.A. A2004

• Manufacturer: C.L.O.M.E.A.

A2004 Reduction bushing.

C.L.O.M.E.A. AT0019

• Manufacturer: C.L.O.M.E.A.

AT0019 Software-controlled pneumatic equipment to safely manage closed geometries.

C.L.O.M.E.A. AT0022

• Manufacturer: C.L.O.M.E.A.

AT0022 Equipment and Software to manage mono-run bending of concave and convex geometries.

C.L.O.M.E.A. PA01F

• Manufacturer: C.L.O.M.E.A.

PA01F Carburised and tempered steel runner kit to contain the stretched winglet.

C.L.O.M.E.A. PA03

• Manufacturer: C.L.O.M.E.A.

PA03 PVC runner to support the compressed areas (only for mono-run bending).

C.L.O.M.E.A. PEF

• Manufacturer: C.L.O.M.E.A.

PEF Software and Hardware for the management of the automatic bar-reading encoder and the photoelectric cell determining the length of the initial straight section, very useful for repetitive working cycles. Auto...

C.L.O.M.E.A. CRM35

• Manufacturer: C.L.O.M.E.A.

High performance hydraulic bending machine for metal profiles. Machine body in cast iron, gears in hardened steel and three steel driving shafts mounted on conical bearings and controlled by a gearmotor. The mach...

C.L.O.M.E.A. CR40

• Manufacturer: C.L.O.M.E.A.

High performance hydraulic bending machine for metal and plastic profiles. Machine body in cast iron, gears in hardened steel and three steel driving shafts, mounted on conical bearings and controlled by a gearmo...

C.L.O.M.E.A. CR120

• Manufacturer: C.L.O.M.E.A.

High performance hydraulic bending machine for metal and plastic profiles. Machine body in cast iron, gears in hardened steel and three ground tempered steel driving shafts, mounted on conical bearings and contro...

Draw Bench - Usefull length: 130 cm

• Manufacturer: GIUSEPPE MEALLI

Supplied without draw tongs, available as accessory. The gears rotate on self-lubricating bushes; the chain also, unlike other benches, is supported by strips in antiwear material. Made in Italy. Drawbench with s...

Draw Bench - short version

• Manufacturer: GIUSEPPE MEALLI

Draw Bench, short version - Usefull length: 850 mm. Supplied without draw tongs, available as accessory. Two drawing speeds: direct drive or 4:1 gear ratio. Maximum wire diameter: 6 mm. Made in Italy. Drawbench ...

C.L.O.M.E.A. CN11

• Manufacturer: C.L.O.M.E.A.

CN11 Numerical control with Linux operating system for multiple-run machining up to 3 radii. Single bar-feed speed, automatic management of the fitting sections and bar check. Network connection and remote assist...

Manual Rolling Mill plate mm 120

Manual Rolling Mill mm 120 Manual Rolling Mill plate mm 120 with reduction gearbox One piece cast iron construction for maximum strength and rigidity. This mill are entirely made in Italy, which translates into g...

C.L.O.M.E.A. CN23

• Manufacturer: C.L.O.M.E.A.

CN23 Numerical control with Linux operating system for multiple and single-run machining up to 12 radii. Two bar-feed speeds, automatic management of the fitting sections, bar check, automatic calculation of spri...