Used Processing in British Columbia, Canada

1990 30" 1400psi Sweet Vertical Start Gas Make-up Separator 3 Phase

• Manufacturer: Nusco

Vessel mounted in compressor building. Mounted on concrete.

1989 24" 230psi Sweet Vertical 1st stage suction scrubber Separator 2 Phase

• Manufacturer: Sure Weld Industries

Vessel mounted in compressor building. Mounted on concrete.

1957 30" Vertical Separator

Pasc condition rating: D | Condition details: SCRAP | Skidded: No | Housed: No | Connection status: Connected | Vessel only: No | Diameter: 30" | Diameter(unit of measure): inches | Separator length: 15' | Separ...

1989 36" 200psi Sweet Vertical Compressor start Gas Separator 2 Phase

• Manufacturer: Sure Weld Industries

Vessel mounted in compressor building. Service type: Sweet | Pasc condition rating: B | Skidded: No | Housed: Yes | Connection status: Connected | Vessel only: Yes | Separator type: Compressor start Gas | Diamete...

1989 30" 100psi Sweet Vertical Surge Drum Separator 2 Phase

• Manufacturer: Sure Weld Industries

Service type: Sweet | Pasc condition rating: B | Skidded: No | Housed: No | Connection status: Connected | Vessel only: Yes | Separator type: Surge Drum | Diameter: 30" | Diameter(unit of measure): inches | Sepa...

Model 34 Headrig Slabber

- RH (clockwide rotation) - 24-5/8" minor diameter - Six (6) knife, bent knife pockets - c/w driven sheave (30-1/2" diameter, 5V, 10 groove) - Heavy duty slide base - 18" stroke trunnion mounted setworks cylinder...

5' Salem Reducer Twin Sharp Chain System

• Manufacturer: Sharp

- To handle logs up to 24" in diameter x 16' long - Sprocket style log turner c/w overhead holddown rolls - 3" wide Sharp Chain c/w hydraulic drive - USNR reducer module c/w step disc head and linear positioners ...

8' PES Composer

• Manufacturer: Canadian Mill Equipment

- Feeder - Tilt hoist - Let down stacker

Durand Raute Rotary Green Veneer Clipper

• Manufacturer: Durand Raute

- 120" double sided rotating knife - 11" by 110" top and bottom anvil rolls - Hydraulic drive for knife rotation - Four infeed holddown arms with belts - 25 HP hydraulic unit with PVB 20 pump - Durand Raute contr...

TimberStar Grade Stamper

• Manufacturer: Canadian Mill Equipment

- Removed May 2015 - Six (6) head mounted onto a stand - Dismantled and ready to load

RAWLINGS ROTARY HOG

- horizontal feed - Model 360 HZ - spiral rotor - 60" wide x 33" high opening - 4" x 9" screen openings - needs rebuilding - located in the Fraser Valley (close to Vancouver, British Columbia)

Flare Saw Guide Resurfacer

• Manufacturer: Canadian Mill Equipment

- Single sided - Digitally controlled - Very accurate - 575 volt

Chip Trailer Dump

• Manufacturer: Canadian Mill Equipment

- 66' long deck (could be lengthened) - c/w HPU - No receiving bin

60" CAE Carriage

• Manufacturer: CAE

- Manufactured approximately 1988 - 3 Knee c/w Sharpe linear positioners - Vee and flat wheels - Cant flippers - Overall knee width 21" (14" between the knee faces) - Two (2) accumulators - Frame is approximately...

30 Unit Truck Bins (3 only)

• Manufacturer: Canadian Mill Equipment

- Three (3) only 30 unit bins c/w hydraulically actuated bin bottoms - Support steel - Two (2) hydraulic power units - Dismantled and ready to load