Used Machine Tools in Saxony, Germany

HEIDENHAIN length measuring system

Length measuring system HEIDENHAIN LS486C ID 329 991-22 approx. 1,5 m connection cable Spare part e.g. for machining center HECKERT CWK400 D ! used, tested !

PAULSTRA all-metal damper

• Manufacturer: PAULSTRA

All-metal damper, machine foot set, leveling foot set, vibration isolator PAULSTRA V1H752-11 Material (all-metal damping pad) CrNi steel wire All-metal damper set consists of 4 feet ! used, tested !

HELLER chip conveyor

• Manufacturer: Heller

Chip conveyor HELLER type BEA 05 Drive motor: 0,3 kW 9.0 rpm 220 / 380 V 3AC, 50 Hz Coolant pump1: Q: 250 l/min, H: 13 m 1.7 kW 2850 rpm 230 / 400 V 3AC 50 Hz Coolant pump2: Q: 100 l/min, H: 2 m 0.24 kW 2750 rpm ...

PAGUS vice

• Manufacturer: Pagus

Machine vice PAGUS on table with graduation 360° rotatable 90° tiltable

KENNAMETAL shrink fit chuck

• Manufacturer: Kennametal

Shrink fit chuck, shrink fit chuck KENNAMETAL HSK A100x25x115 HSK100ATT25115M New !

WMW 4-jaw chuck

• Manufacturer: WMW

4-jaw chuck WMW Original Perthel Machine side: Mounting ring: Diameter: Ø 217 / 190 mm, Width: 13 / 16 mm with chuck key Used, tested!

POKOLM shrink feed kit

• Manufacturer: POKOLM

Shrink fit chuck set, shrink fit chuck POKOLM 50 Ø 750 S SK 40 used, tested !

GARANT shrink lining set

• Manufacturer: Garant

Shrink fit chuck set, shrink fit chuck GARANT 302325 SK 40 302235 SK 40 used !

GARANT shrink lining set

• Manufacturer: Garant

Shrink fit chuck set, shrink fit chuck GARANT 302352 SK 40 used, tested !

GARANT shrink lining set

• Manufacturer: Garant

Shrink fit chuck set, shrink fit chuck GARANT 302356 SK 40 used, tested !

GARANT shrink lining set

• Manufacturer: Garant

Shrink fit chuck set, shrink fit chuck GARANT 302235 SK 40 used, tested !

PAGUS clamping device

• Manufacturer: Pagus

Clamping device, machine vice PAGUS clamping jaw thread: M24 x 3.0, depth: 45 mm used, tested !

WMW Bezel

• Manufacturer: WMW

Bezel, fixed bezel, setting stick WMW Bakelite handles partially damaged! Used, tested!

PAGUS bearing pedestal

• Manufacturer: Pagus

Bearing block for tailstock PAGUS Bearing seat (left): Diameter: Ø 120 / 100 mm, Depth: 26 / 17 mm Bearing seat (right): Diameter: Ø 110 / 95 mm, Depth: 42 / 17 mm 4x Threaded holes: M8 x 1.25, Depth: 20 mm New!

WMW bearing pedestal

• Manufacturer: WMW

Bearing block, counter bearing for milling spindle WMW Ø 55 mm x 130 mm Distance spindle center - upper edge of dovetail: 130 mm dovetail guide: 182 / 146 mm, height: 26 mm, width: 60 mm used, tested !