Used Processing in British Columbia, Canada

37' MILL POWER VIBRATING CONVEYOR

• Manufacturer: Mill Power

- unbalanced - 24" wide x 37' long - c/w grizzly - metal trap c/w magnet - very good condition (never been installed)

Log Haul Conveyor

- Heavy duty trough, approximately 60' long - WD480 box chain (8" pitch x 14-1/2" wide) - Tail pulley c/w air bag tension system - No drive

39' EDEM VIBRATING CONVEYOR

- balanced - 18" wide - c/w 5' fiberglass section - c/w grizzly

23" x 25' Long Belt Conveyor

- Frame is 27' long x 38" wide x 43" high

30" x 92' Troughing Conveyor

- Truss frame construction c/w catwalk (Approx 7' wide x 4'-4" high) - Two (2) sections (47'-5" and 44'-6") - Drive assembly - Head pulley assembly - No tail pulley - Belt

HYDRO-O FLEX TRAILER DUMP

- Built in 1994 - Back on style - 65' long deck x 10" wide - 50 ton capacity - 63 degree tilt angle - Two (2) hydraulic cylinders (chrome plated) - Hydraulic Power Unit (575/3/60) - Hopper c/w twelve (12) strand ...

16' CanCar Half Taper Infeed

• Manufacturer: Canadian Mill Equipment

- Alligator chain - 2 infeed spike rolls c/w 5 HP motors - Infeed drive complete - Good condition - New spare top & bottom chain

CanCar Side Head Module

• Manufacturer: CanCar

- Side head module - 3 knife segments - 2 Coleman inserted outfeed rolls - 5 HP - No motors

ALLIED #40 Material Fan with 30 HP

• Manufacturer: Allied

-mounted on stand - 30 HP - still installed

Large Blower

- Shroud is 102" diameter x 28" wide - Fan is 61" diameter x 20" wide - Was run by a 150 HP motor (not included) - Needs paint job but mechanically sound - Located on West Coast of BC - Ready to load

Chicago Boiler Air Dryer

• Manufacturer: Chicago Boiler

- Two (2) air tanks - 31" diameter x 6'-4" long tank - 7.5 HP, 230/460 volt, 1750 RPM - Maximum psi - 150 @ 500 OF - Tank serial #807442-1 & 807442-2 - Built in 1980 - Some piping

1000 Gallon FKO Vessel - 15782

• Manufacturer: Rivers End

- 1000 gallon flare knock out tank. less house and heat, has skid/tub - 4" in and out - built so far by River's End

STEP FEEDER

- Double acting step feeder - Six (6) steps approximately 10 feet long - No end walls - Electrically driven (drive not included) - Disassembled

36" x 48" Falcon Rotary Hog

• Manufacturer: Falcon RME

- Built in 1992 by Clarkes - Drop feed - 36" x 48" Rotary Hog c/w fixed hammers - Two (2) 8V-8 groove sheaves on rotor - No motors included (originally driven by two (2) 250 HP motors) - Cylinder operated hinged ...

20' x 60' Roof Top Pull Chains (2 only)

• Manufacturer: Canadian Mill Equipment

- Five (5) runs of roof top chain c/w rollers on side - Approximately 50' long - Electric motor/reducer drive unit - Still installed