Used Machine Tools in Lisbon, Portugal

Cutting tools

Cutting tools for machines such as lathe supports and inserts, 2 and 4-blade milling cutters, taps and dies, drills of various sizes, clamping presses, drill bushings and lathe bushings, collets and collet holder...

Drilling machine Compair Holman Voltrak wagon drill

• Manufacturer: CompAir

Drilling machine Compair Holman Voltrak wagon drill

REWINDING MACHINE ACCESSORIES

REWINDING MACHINE ACCESSORY ALLOWING ONLY ONE OPERATOR TO MANOSIAR REWIND CABLE OF COILS. THESE CABLES CAN BE DRIVERS, ROUND CABLES, TWISTED, COVERED OR KNOTS, UP TO 100 mm DIAMETER CAN BE MEASURED SIMULTANIALLY,...

Machine with Milling Table RF40

Drilling and Milling Machine RF- 40 (used) Manual cross-motion table Head with tilt for angles 6 Speeds from 100 to 2500 rpm Drilling capacity 30 mm CM3 400 Volt Motor Right/Left rotation direction inverte...

HIW 90 Bit Puller

Hydraulic Punch Puller HIW 90, 90 ton capacity, 2 workstations, Geka or Peddingaus tool system.

SURE FIRST Penetration Erosion

SURE FIRST brand penetration erosion, model DM-408, Fagor digital reader.

MHS 350

• Manufacturer: MHS

SELLING NEW HYDRAULIC HAMMER STILL WITH MANUFACTURER WARRANTY Technical specifications: Others: - Machine ready base - Hoses according to the machine - Manual lubrication pump - 2 cartridges of mass 400g - Instru...

Atlas Copco's Odex System

• Manufacturer: Atlas-Copco

Atlas Copco's Odex system allows simultaneous drilling and coating of deep holes in all types of formations, even those that contain large blocks. The method is based on the use of a pilot bite and an eccentric r...

Makimak corner cutter

• Manufacturer: Makimak

Used MAKIMAK brand pneumatic corner cutter in perfect general working condition. Pneumatic pedal actuation Cutting capacity 1.5 mm It is placed on a base with wheels so it can be moved if necessary.

TOS lathe machine

• Manufacturer: TOS

Czech lathe from TOS (used) Distance between points of 500 mm Spindle hole of 22 mm Turnable to the 250 mm bar 125 mm chuck with 3 clamps 10 speeds from 36 to 2100 Rpm. Fully overhauled in excellent working condi...

ROLUX CUT 40 plasma cutting machine

Plasma cutting machine with cutting capacity of 12 mm, 230 volts.

HELLER lathe

• Manufacturer: Heller

HELLER lathe – new Distance between points of 1 m Turnable to 360 mm bar Fagor digital display

PBL750 mechanical lathe

Mechanical lathe, model PBL750 230 Volt motor Bench

PBL 1000 Mechanical Lathe

New PBL 1000 mechanical lathe. 230 Volt Motor Distance between points 1000 mm Taptable to 320 mm busbar Turnable at armhole 450 mm Tree hole 38 mm Metric and Inch threads 4+4 clamp bushing 3+3 clamp bushing Candi...

PBL400 mechanical lathe

PBL 400 Lathe Distance between points 400 mm Turning diameter 210 mm Turning diameter on the carriage 110 mm Hole length 100 mm Carriage stroke 75 mm Upper carriage stroke 55 mm Spindle bore 21 mm Spindle taper M...