Used Materials Testing in Flanders, Belgium

S166-03 Test gauge, 30° angle

Cone test gauge, 30° angle

C173/ U Box for testing concrete

U-box German made

S E044-41N Probe 100g. for tests on gypsum+tang

Probe 100g for tests on gypsum + tang EN 196-3:2005

A081-01 : Lightweight aggregates crushing resistance

Lightweight aggregates crushing resistance Standard : EN 13055-1 METHOD 1 Apparatus for the determination of the crushing resistance of lightweight aggregates having diameter from 4 to 22 mm, and a volumic mass o...

B024 : Permeameter

Permeameter Mainly used in situ to perform and to check the permeability and drainage on road carpets, concrete pavements, tamped earth etc. The test consists in filling the cylinder with water, after ermetically...

Calibration Proctor Mould Small diam 100

• Manufacturer: Proctor

Calibration of a Proctor Mould: diameter and height The calibration/testing services offered in this quotation are performed by European Lab Services site Sint-Niklaas. European Lab Services is accredited accordi...

Calibration Pull off Tester

Calibration for a Pull off tester with one channel under ISO17025 accreditation 327-CAL The calibration/testing services offered in this quotation are performed by European Lab Services site Sint-Niklaas. Europea...

Justification Automatic Pull off Tester

Rectification of an automatic Pull off tester DY-2 following ISO7500-1 (wièout annex C) èe tester will be ready for a calibration under ISO7500-1 after èie rectification (calibration not included)

Calibration Ductilometer three lc

Calibration Ductilometer Apparatus with three load cells

Calibration Blaine Apparatus: k-factor EN196-6

Calibration Blaine Apparatus k-factor following EN 196-6

E017 Fineness of fly ash by wet sieving

Fineness of fly ash by wet sieving

C199 Unit weight measure 10 Litres, EN 12350-6, EN 1097-3

Unit weight measure 10 Litres, EN 12350-6, EN 1097-3

C194 Concrete pocket penetrometer

Concrete pocket penetrometer

Installation and training on site by producer

Installation and training on site for èe Four Point Bending Beam Testing System

Calibration Load Measuring up to 3000kN

Calibration Load Indicating Device up to 3000 kN The calibration/testing services offered in this quotation are performed by European Lab Services site Sint-Niklaas. European Lab Services is accredited according ...