Used Sensors in Italy

300HE100 Tecnosens

• Manufacturer: Tecnosens

Piezoceramic ultrasonic transducer, typical drive frequency 300 kHz, 9 mm diameter. Features Operating temperature: -20°C to +70°C Storage temperature: -30°C to +70°C Operating humidity: 15 to 90% RH Storage humi...

KB1581 Tecnosens

• Manufacturer: Tecnosens

The KB1581 model consists of an infrared LED and a Light-Modulation Photo IC. Features: Light-modulation type. Low cost. Dustproof. The distance between the emitter and receiver can reach up to 700 mm. Applicatio...

KB1281 Tecnosens

• Manufacturer: Tecnosens

The KB1281 photo switch consists of an infrared LED and a photo IC. Its main features are: - The distance between the emitter and the detector can be set to a maximum of 400 mm; - Resistant to noise caused by amb...

KB1284 Tecnosens

• Manufacturer: Tecnosens

The KB1284 photo switch consists of an infrared LED and a phototransistor. Its main features are: - The distance between the emitter and the detector can be adjusted from 1 to 100 mm; This photo switch is recomme...

FCX-MVL-F Tecnosens

• Manufacturer: Tecnosens

The board allows measurement of O2 concentration in the range of 0.1-25% . Zirconium oxide technology avoids calibration procedures and allows for particularly long life. It is a board suitable for measurement in...

T8720 Universal leak tester for micro-flows

Leak measurement with flow sensor Leak display in volumetric mode (cc/h or cc/min) with a classic leak testing tool is restricted by setting the volume of the piece being tested which, using mathematical algorith...

T2730 T2730 is the new digital portable calibrator of ForTest T Series

T2730 is the new digital portable calibrator of ForTest® T Series. Enclosed in a container of anodized aluminium with shatterproof plexiglass front, we find a completely new circuit board and a mass flow meter se...

T2710 T2710 is the new digital portable calibrator of ForTest T Series

T2710 is the digital portable calibrator for micro flow of ForTest® T-Series. Enclosed in a container of anodized aluminium with shatterproof plexiglass front, we find a completely new circuit board and a mass fl...

T8999 Hydrogen leak detectors

Easy and clean leak identification. T8999 is an equipment designed to meet the increasing need for easy and clean identification of the position of the leak on a piece being tested, therefore eliminating the need...

T4990 Absolute pressure decay micro leak tester

Born to be integrated on automatic, semi automatic and rotating benches, it provides an hardware that can be compared to that one of top series equipments, and with a measurement accuracy of not less than 0,1 Pa....

T6961 Remote differential entry-level leak tester

High speed for small volumes. T6961 was designed for ultra fast testing of small parts (pneumatic valves, pressure switches, micro-valves in plastic for medical use, needles, catheters, biomedical components etc....

T8060 Differential Dual Absolute Leak Tester

A touch of innovation The new video controller “ForTest MMI” brought a superior level of human-machine interaction, thanks to an innovative capacitive panel in tempered glass, around a splendid 6.2” colour displa...

T8980 "Compliance" universal leak tester

Shut-off testing. In some particular situations, i.e. when the maximum permitted leak is too small, the only solution is to close the piece being testing inside a hermetic bell and pass to a shut-off "compliance"...

T8970 Universal continuous measurement leak tester for the gas sector

Continuous measurement for the gas sector. T8970 is a particular leak testing equipment with continuous measurement, designed for specific parts with gas ramps, stoves or repair stations. This technology will ens...

T8990 Absolute decay universal leak tester

A touch of innovation The new T8990 leak tester was designed to improve what was considered the best device in ForTest's history, the M8990. The new video controller “ForTest MMI” brought a superior level of huma...